If you work with the real Arduino you can skip the Tinkercad specific instructions.

Now that you know how the Arduino and the RGB LED work, you are ready to make the first update for AutoFRAME.

The requirements for AutoFRAME version 0.1 are:

The AutoFRAME automatically takes a picture every 4 seconds by sending a signal to Arduino Pin 6 (to which we will connect the camera later, but where nothing is connected at the moment) and at that moment also takes a 'flash' with the RGB led by letting all the colours burn simultaneously for a maximum of 0.5 seconds.

Start with the Tinkercad project you made in the assignment "Arduino - connecting components with breadboard and jumper wires".

You start with the code you made in this assignment. However, if it no longer works, you can always take the Blink example again.

void setup()
{
 pinMode(13, OUTPUT);
}

void loop(()
{
 digitalWrite(13, HIGH);
 delay(1000); // Wait for 1000 millisecond(s)
 digitalWrite(13, LOW);
 delay(1000); // Wait for 1000 millisecond(s)
}